刀片服务器上10Gb mezzanine和Pass-Thru模块连接速度的问题

[MUDBOY]

有个问题，

10Gb mezzanine是否能够以不同的速度让两个端口分别连接相邻的两个interconnect bay，比如一个端口连接到slot 5 bay上的10Gb PT模块，另一个端口连接到slot 6 bay上的1Gb PT模块。

请高手指教，感谢！

上个10Gb PT模块的图，支持1Gb and 10Gb连接
http://h18004.www1.hp.com/products/quic ... 8_div.HTML

13508_ov.jpg

[MUDBOY]

自己找了些信息，更新一下

目前看来至少在相邻的两个bay（比如slot5和slot6）上安装一个10Gb PT模块和一个1Gb PT模块没有问题的。这个是允许的。

[HONG]

我理解在NC551或者NC553上是不能够以不同的速度运行的，只能工作在相同的速度，这里应该是1Gb

参考BL465G7和BL460G7网络端口部分的配置说明: Both Components will operate at the same speed.

Network Controller:
Integrated NC553i Dual Port FlexFabric 10Gb Adapter supporting autosensing 10Gb/1Gb Ethernet, FCoE, Flex-10,
TCP/IP offload engine, hardware-based accelerated iSCSI, and iSCSI boot.
NOTE: Fibre Channel over Ethernet (FCoE) capability requires the use of an HP Virtual Connect FlexFabric 10Gb/24-
port Module or HP 10GbE Pass-Thru Module. Learn more at: www.hp.com/go/virtualconnect.
NOTE: Each port is autosensing 1 Gb / 10 Gb, and can interoperate with 1 Gb HP BladeSystem c-Class interconnect
components. Both ports will operate at the same speed.
One (1) additional 10/100 server adapter dedicated to iLO 3 Management

Network Controller:
One (1) integrated NC551i Dual Port FlexFabric 10Gb Converged Network Adapter supporting stateless TCP/IP offload, TCP Offload Engine (TOE), Fibre Channel over Ethernet (FCoE) and iSCSI protocols
NOTE: Flex-10 capability requires the use of an HP Virtual Connect Flex-10 10Gb Ethernet module. Learn more at: www.hp.com/go/virtualconnect
NOTE: Fibre Channel over Ethernet (FCoE) capability requires the use of an HP Virtual Connect FlexFabric 10GB/24-port Module or HP 10GbE Pass-Thru Module.
NOTE: Each port is autosensing 1 Gb / 10 Gb, and can interoperate with 1 Gb HP BladeSystem c-Class interconnect components. Both ports will operate at the same speed.
One (1) additional embedded 10/100 network adapter dedicated to iLO 3 management