HPFOCUS

Arno 写了：I am using the X7 port of the FlexFabric module as an uplink, I am now unable to configure this at the moment, there are some previous enclosures that are using X7 as uplink.

During the setup customer encounters following error message :

代码： 全选

->add uplinkport  enc0:2:X7 network=tr-mgmt-b
ERROR: The specified port is a stacking-link port.

Any idea ?
Before I could setup X7 as normal or stacking uplink.

Mark 写了：Is there a SFP installed in X7? If not it is a stacking link.

Dan 写了：I concur.

The internal connection is only disabled when an SFP is installed into the external port.

So until that happens, VC owns both ends of the "cable" and thus makes it a stacking cable.