HPFOCUS

ENHANCEMENTS:
- Provides support for dual USB keyboards in the DOS environment.
- Provides the location, manufacturer, size, and speed for each memory slot in
the F10 BIOS setup.
- Updates the Management Engine BIOS Extension (MEBx) to version 7.0.0.0062.
- Updates the preboot execution environment (PXE) ROM to version 1.3.95.0. NOTE:
The updated PXE code provides security enhancements that possibly require
configuration changes on the PXE server.
- Provicesd support for Wake on LAN (WOL) on systems running while on battery
power.
- Provides the Max SATA speed option in the F10 BIOS Setup which enables the
maximum speed of the SATA drive to be set to 6.0 Gbps or to 3.0 Gbps.
FIXES:
- Fixes an issue where the system BIOS cannot be flashed in unattended mode if
the BIOS password contains more that 16 characters. This issue occurs only when
the BIOS is flashed in delay mode.
- Fixes an intermittent issue where the BIOS Power On feature does not wake the
system from the off state.
- Fixes an intermittent issue where the optical drive tray does not eject
properly when the eject button is pressed.
- Fixes an intermittent issue where the system battery does not charge properly
after it has been fully discharged.
- Fixes an intermittent issue where a system using a Solid State Drive (SSD)
system does not boot properly.

ENHANCEMENTS:
- Provides support to bypass the power-on password during a warm boot.
FIXES:
- Fixes an issue where the BIOS Config Utility in the F10 BIOS Setup does not
distinguish between the primary and the secondary hard drives.
- Fixes an intermittent issue where data packets are lost while transferring
data on a system connected to a network.

林之乎 写了：我之前用8760的时候，也发现了降速问题，忘记Bios是哪一版的了，但是经过调试发现一个很奇怪的问题，我在BIOS里面把硬盘速度调成3G的那个范儿可以得到sata3的速度，很是奇怪
PS：突然想起8770的BIOS是可以选中文界面的，忘记告诉大家了

坐山雕zp 写了：

林之乎 写了：我之前用8760的时候，也发现了降速问题，忘记Bios是哪一版的了，但是经过调试发现一个很奇怪的问题，我在BIOS里面把硬盘速度调成3G的那个范儿可以得到sata3的速度，很是奇怪
PS：突然想起8770的BIOS是可以选中文界面的，忘记告诉大家了

是的，昨晚经过测试也发现了这个问题，从26或者27升到28以上，在硬盘速度那里调成3g，硬盘反而是sata3的速度，m4读取达到了500m，但是还有个问题，调到3g以后就不能再调了，再调一次6g
，速度又降回sata2的速度，然后你再调到3g也没用了，只有重新刷回27以下的bios再次升级到28或者29

雕兄你试试只用电池的情况下开机，看看屏幕能不能正常显示啊，帮忙测试一下，因为我的qd 4000m是这个样子的，但是显卡是dell版本的，所以不知道是vbios还是主板bios的事！

坐山雕zp 写了：

雕兄你试试只用电池的情况下开机，看看屏幕能不能正常显示啊，帮忙测试一下，因为我的qd 4000m是这个样子的，但是显卡是dell版本的，所以不知道是vbios还是主板bios的事！

我的显卡是原装的3000m，电池下开机正常，估计老兄的4000只要刷个vbios就行，其实我觉得老兄买个q3000m还便宜，而且很能超，性能不比4000m差，我的3000驱动里开机自动超频到750温度无变化，温度超过85又自动降回默认（这么设置的，但是从来没超过85 ）

QQ截图20130308123505.png